Sony CPD-17F03 - Manual (Page 6)

6
Plug and Play
This monitor complies with the DDC

1 and DDC2B, which
are the Display Data Channel (DDC) standards of VESA.
When a DDC1 host system is connected, the monitor
synchronizes with the V.CLK in accordance with the VESA
standards and outputs the EDID (Extended Display
Identification) to the data line.
When a DDC2B host system is connected, the monitor
automatically switches to the DDC2B communication.
DDC

is a trademark of Video Electronics Standards
Association.
Damper Wire
Using a white background, very thin horizontal stripes on
the screen are visible as shown right. These stripes are
damper wires. These wires are attached to the aperture
grille inside the Trinitron tube and are there to damp
vibrations of the aperture grille in order to prevent them
from influencing to the picture quality.
Use of the Tilt-Swivel
45°
15°
45°
With the tilt-swivel base, this unit can be adjusted to be
viewed at your desired angle within 90° horizontally and
20° vertically.
To turn the unit vertically and horizontally, hold it at its
bottom with both hands.
5°
Specifications
Picture tube 0.25 mm aperture grille pitch
17 inches measured diagonally
90-degree deflection
Viewable image size Approx. 327
×
241 mm (w/h)
(12 7 / 8
×
9 1 / 2 inches)
15.9” viewing image
Resolution Horizontal: Max. 1280 dots
Vertical: Max. 1024 lines
Display picture size Approx. 300 × 225 mm (w/h)
(11 7 / 8
× 8 7 / 8 inches)
Deflection frequency Horizontal: 31.5 to 64 kHz
Vertical: 50 to 120 Hz
AC input voltage/current
100 to 120 V, 50/60 Hz, 1.8 A
220 to 240 V, 50 – 60 Hz, 1 A
Dimensions 406
Ч
426.5
Ч
451 mm (w/h/d)
(16
Ч
16 7 / 8
Ч
17 7 / 8 inches)
Mass Approx. 19.0 kg (41 lb 14 oz)
Design and specifications are subject to change without
notice.
Approx. 6 cm
Approx. 6 cm
Damper wire