Sony UWP-C1/C2 - Manual (Page 15)

15
D BATT (battery) indication
Shows the battery condition.
For details, see “Power Supply” on
page 20.
E CH (channel) indication
Shows the transmission channel. Each
time you press the SET button, the
channel indication changes as follows.
For details, see “Settings” on page
28.
5 + (+ selection) / – (– selection/
reset) buttons
Press these buttons to set the
transmission channel, frequency, or
attenuation level of the input signal.
The “–” button resets the accumulated
battery use time to “00:00”.
6 SET button
Press to change display parameters.
For details, see “Settings” on page
28.
Transmission
channel
Transmission
frequency
Attenuation
level of the
input signal
Accumulated
battery use
time
Press
the
SET
button.
Portable diversity tuner
(URX-P1)
1 Antennas a/b
The angle of the antennas can be
adjusted manually.
2 MONITOR connector (3.5-mm
diameter stereo mini jack)
To monitor the tuner output, connect
the headphones to this connector.
3 RF (radio frequency) indicator
Indicates the strength of the RF input
signal.
On in green : RF input is 15 dBµ*
or more.
Off : RF input is less than 15 dBµ*.
......................................................................................................................................................................
* 0 dBµ = 1 µV
EMF