Simplicity Manufacturing RZT22500BVE2 - Manual (Page 19)

250 Z & Javelin Series
7/2006
MOWER BELT REPLACEMENT
44” & 50” Decks:
1. Park the rider on a smooth, level surface such as a
concrete floor. Disengage the PTO, lock the motion
control levers into their neutral locked positions, turn
off the engine, and remove the ignition key.
2. Remove the hardware (B, Figure 24) securing the
belt guards (A) to the mower deck, and remove the
guards.
3. Raise the mower deck to its highest cutting position.
4. Pull back firmly on the belt tensioning idler (E, Figure
23) in the direction indicated, and remove the belt
from the left arbor pulley (A).
5. Remove the old belt from the remaining pulleys.
6. Reversing steps 4 - 5, install the new belt, following
the routing in Figure 23. Be sure to replace the belt
guards.
To avoid damaging belts, DO NOT
PRY BELTS OVER PULLEYS.
Figure 23. Mower Belt Routing - 44” & 50” Decks
A. Right Arbor Pulley
B. Left / Center Arbor Pulley
C. PTO Pulley
D. Stationary Idler
E. Belt Tensioning Idler
A
C
E
Figure 24. Belt Guard Removal
A. Belt Guard (Left side shown, right side similar)
B. Securing Hardware
A
B
TP 300-5141-01-HZ-SN 19
D
B
FUSE REPLACEMENT
1. Park the rider on a smooth, level surface such as a
concrete floor. Disengage the PTO, lock the motion
control levers into their neutral locked positions, turn
off the engine, and remove the ignition key.
2. Raise the seat. The fuse holders are located on the
right side of the rear seat support.
3. Remove and check the suspected fuse (or fuses). If
blown, replace with a fuse with a rating equal to the
ratings indicated in Figure 25.
WARNING
Do not use a fuse with a rating other than that
specified. Serious equipment damage may result.
A
Figure 25. Fuse Designations and Ratings
A. Accessory - 30 Amp
B. Start - 15 Amp
B