Scag Power Equipment STC - Manual (Page 32)

28
Section 7
Figure 7-7 Kawasaki Fuel Filter Location
To avoid injury from burns, allow the mower to cool
before removing the fuel tank cap and refueling.
1. Close the shutoff valve (located on the left side for the
KA model, right side for the KH model). Remove the
two clamps securing the fuel filter to the fuel hose.
Remove the fuel filter, noting the proper direction.
2. Install a new fuel filter. Be sure it is installed in the
proper direction. Secure to the fuel hose using the two
clamps.
7.6 ENGINE AIR CLEANER
A. Cleaning and/or Replacing Air Cleaner
Element
For any air cleaner, the operating environment dictates
the air cleaner service periods. Inspect and clean the
air cleaner element after every 100 hours of operation or
bi-weekly, whichever occurs first and replace the
element if required.
-NOTE-
In extremely dusty conditions it may be necessary
to check the element once or twice daily to
prevent engine damage.
1. For the KH model, remove the wing nut securing the
air cleaner cover to the engine. For the KA model,
remove the two clips securing the air cleaner cover
to the engine. Remove the air cleaner cover and set
aside.
2 Remove the air cleaner and inspect.
3. Clean or replace the air cleaner and foam pre-
cleaner as recommended by the engine
manufacturer.
STC99EFF
FUEL FILTER
FUEL FILTER
STC99KFF
Figure 7-8 Kohler Fuel Filter Location