Sony CMT-ED1/ED1A - Manual (Page 18)

18
Playing a tape
You can play any type of tape, TYPE I
(normal), TYPE II (CrO
2
) or TYPE IV (metal).
The deck automatically detects the tape type.
4
p
P
º/‚
3
VOL+/–
≠/±
DOLBY NR
1/u
(Power)
4
π
∏
2
≠º/
‚±
1
VOLUME
+/–
1
Press § PUSH of the front cover
and insert a recorded tape into the
deck.
2
Press FUNCTION repeatedly until
“TC” appears.
3
Press DIR MODE on the remote
repeatedly to select to play one
side or * to play both sides.
4
Press · (or TAPE ª· on the
remote).
Press ª (or TAPE ª· on the remote
again) to play the reverse side. The tape
starts playback.
To
Stop play
Pause
Fast-forward
or rewind
Find the beginning
of the current or
succeeding track
Remove
the cassette
Adjust the volume
Tips
• Pressing TAPE ª· on the remote while the
power is off automatically turns on the power and
starts tape playback if there is a tape in the deck
(One Touch Play).
• You can switch from another source to the tape
deck just by pressing TAPE ª· on the remote
(Automatic Source Selection).
• When you want to reduce the hiss noise in low-
level high-frequency signals, press DOLBY NR on
the remote before step 4 so “a” appears.
* The deck stops automatically after playback both
sides five times.
With the side you want
to play facing forward
Do this
Press π.
Press ∏. Press again to
resume playback.
During stop, press ‚±
or ≠º (or º/‚
on the remote).
During playback, press
≠º or ‚± (or ≠/±
on the remote).
Press § PUSH.
Press VOLUME +/– (or
VOL +/– on the remote).
1/u
(Power)