Message: >can't open file: 192, Message: >wrong file type, Message: unit hangs on “burning boot” message – Symmetricom XLi IEEE 1588 User Manual
Page 157: Log on to the xli and enter the following command, An example xli response is, Number is the firmware version number. the, Number in, F100 ver, Proj rev, File system
XLi IEEE 1588 Clock
149
997-01510-03, Rev. C, 12/12/2006
2
5
1
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
Message: >Can't open file: 192-####.##
Cause: There's a problem with the FTP server that is preventing access to the file. Verify the following:
•
The FTP server is correctly configured.
•
The anonymous user account is enabled.
•
The anonymous user account password is “guest”.
•
The anonymous user account has read access to the ftpworkfiles directory.
•
The ftpworkfiles directory located in the anonymous user's home directory.
•
The FTP server is running.
•
There aren’t any other ‘anonymous’ users logged into the FTP server.
Try connecting to the FTP server as ‘anonymous’ using an FTP client. You should automatically see the
product name directory (e.g., “XLi”) you created inside the anonymous users home directory (e.g.,
“c:\ftpworkfiles\”). Open the product name directory. You should see the firmware upgrade files you put
there. If either the product name directory or the firmware upgrade files aren’t visible, there’s a problem
with the FTP configuration.
Message: >Wrong File type
You may be using the wrong firmware files for the product being upgraded. This may be due to the
incorrect files being place in the upgrade directory. It may also be that the wrong directory was entered
(one for another product) in the path information on the F100 command line. ‘Wrong file type’ is also
associated with ‘Can’t open file’ errors - see the preceding message.
Message: Unit hangs on “Burning Boot” message.
Check that your IP Address, Subnet Mask, and Default Gateway of the XLi are correctly configured.
FAQ
How does one check the unit’s firmware version number?
Log on to the XLi and enter the following command:
> F100 VER
An example XLi response is:
F100 VER
BOOTLOADER
192-8000
SOFTWARE
192-8001
FILE SYSTEM
192-8002v1.80
NVRAM VER
5
PROJ REV
#1.80
The “
PROJ REV
” number is the firmware version number. The “
v
” number in “
FILE SYSTEM
” is the file
system version number, which may not be the same as the firmware version number.