Skylink SC-100 - Manual (Page 15)

– 25 –
BATTERY MAINTENANCE
MOTION SENSOR BATTERY
The Motion Sensor operates on a 9 volt alkaline battery accessible beneath a
sliding panel on the bottom of the unit. All remote sensors come with the battery.
Disarm the Control Panel before replacing all batteries.
When low battery level is detected, the motion sensor will beep to alert you the
battery needs to be replaced. When the low battery signal appears, it will not trans-
mit any signal to the receiver even motion is detected. Therefore, you should
replace the battery as soon as the low battery signal appears.
Note: Alkaline battery must be used.
To replace the Motion Sensor battery:
1. Slide to remove the sensor from the ball-head joint.
2. Undo the screw and remove the battery cover.
3. Take the old battery out of the battery compartment.
4. Disconnect the old battery from the connector wire.
5. Connect the new alkaline battery to the connector
wire.
6. Put the new battery into the battery compartment.
7. Close the battery cover and re-insert the screw.
8. Slide the unit back to the ball-head joint.
– 26 –
+
-
DOOR/WINDOW SENSOR BATTERY
Each door/window sensor operates on a 12 volt
alkaline battery that is inside the transmitter. The
sensors come with the batteries already installed.
To replace the battery:
1. Push on the clip at the bottom of the transmitter
case with a sharp object (such as a paper clip
or pen knife) and pull it away from the backplate.
2. Pry out the old battery from one end.
3. Push the new battery back into place. A diagram
beside the battery well indicates which end is
positive and which is negative.
4. Snap the transmitter back onto the backplate.
KEYCHAIN TRANSMITTER BATTERY
The Keychain Transmitter operates on a 12 volt alkaline battery which is installed
at the factory.
There are two screws on the back of the transmitter that holds the case together.
To replace the Keychain Transmitter battery:
1. Undo the two screws on the back of
the transmitter.
The back will then come off.
2. Using a small screwdriver or pen
knife, pry out the old battery from one
end.
3. Place the new battery in position.
A diagram beside the battery well
indicates which end is positive and
which is negative.
4. Close the battery cover and re-insert
the two screws.
BATTERY MAINTENANCE
-
+