Sony DAV-IS10 User Manual
Page 16
masterpage:Left
specdef v20060111
filename[G:\FM\Sony\0508\3212589121\3212589121DAVIS10\gb04gsb.fm]
model name [DAV-IS10]
[3-212-589-12(1)]
16
US
G
e
tting
Star
te
d –
B
A
SIC –
3
Connect the cords to the AM antenna (aerial) terminals.
The cords can be connected to either terminal.
Note
• Do not place the AM loop antenna (aerial) near the system or other AV equipment, as noise may result.
Tip
• Adjust the direction of the AM loop antenna (aerial) for best AM broadcast sound.
4
Make sure the AM loop antenna (aerial) is connected firmly by pulling softly.
To connect the FM wire antenna (aerial)
Connect the FM wire antenna (aerial) to the FM 75
Ω COAXIAL jack.
Note
• Be sure to fully extend the FM wire antenna (aerial).
• After connecting the FM wire antenna (aerial), keep it as horizontal as possible.
Tip
• If you have poor FM reception, use a 75-ohm coaxial cable (not supplied) to connect the control unit to an outdoor
FM antenna (aerial) as shown below.
DMPORT
Insert until this
part.
Insert the cords pushing down the terminal clamp.
DMPORT
FM wire antenna (aerial)
(supplied)
FM 75
Ω COAXIAL jack
Outdoor FM antenna (aerial)
Rear of the control unit