Sharp MX-M1100 - Manual (Page 3)

1
For the users of the fax function
FAX interface cable and Line cable:
These special accessories must be used with the device.
Important Notice for New Zealand Users
General
"The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that the item
complies with minimum conditions for connection to its network. It indicates no endorsement of the product by Telecom,
nor does it provide any sort of warranty. Above all, it provides no assurance that any item will work correctly in all
respects with another item of Telepermitted equipment of a different make or model, nor does it imply that any product is
compatible with all of Telecom's network services."
This equipment is not capable, under all operating conditions, of correct operation at the higher speeds for which it is
designed. Telecom will accept no responsibility should difficulties arise in these circumstances. This condition typically
applies to 56 kbit/s modems.
This equipment shall not be set up to make automatic calls to Telecom's 111 Emergency Service.
This equipment should not be used under any circumstances that may constitute a nuisance to other Telecom
customers.
This equipment may not provide for the effective hand-over of a call to another device connected to the same line.
In order to operate within the limits for compliance with Telecom's specifications, the associated equipment shall be set
to ensure that automatic calls to different numbers are spaced such that there is not less than 5 seconds between the
end of one call attempt and the beginning of another.
The Declaration of Conformity can be viewed at the following URL address.
http://www.sharp.de/doc/MX-FXX1.pdf