Sony DSR-DR1000A - Manual (Page 67)

67
Menu Contents
Ch
ap
te
r 6
Men
u
Set
tin
g
(For DSR-DR1000A only)
SETUP ADD [> Setup add]: Determine whether or not to add
black setup to analog video output signals.
* OFF [>> OFF]: Do not add black setup.
ON (ADD) [>> ON]: Add black setup.
(For DSR-DR1000A only)
CC(F1) BLANK [> CC1 blank]: Select whether to mute the
closed caption signal to be superimposed on the 1st field
of the output video signal.
* OFF [>> OFF]: Do not mute.
ON [>> ON]: Mute.
(For DSR-DR1000A only)
CC(F2) BLANK [> CC2 blank]: Select whether to mute the
closed caption signal to be superimposed on the 2nd field
of the output video signal.
* OFF [>> OFF]: Do not mute.
ON [>> ON]: Mute.
WIDE MODE [> Wide mode]: Determine whether to retain
wide-screen aspect ratio information accompanying video
being recorded or played back.
* AUTO [>> Auto]: When video being recorded or played back
is accompanied by wide-screen aspect ratio information,
retain the information.
OFF [>> OFF]: Ignore wide-screen aspect ratio information.
ON [>> ON]: Whenever recording or playing back video, retain
wide-screen aspect ratio information.
ESR MODE [> ESR mode]: Select whether to enable the edge
subcarrier reducer (ESR).
* OFF [>> OFF]: Do not enable.
ON [>> ON]: Enable.
When playing back a composite signal, set this to ON.
PROCESS CONTROL [> Proc
ctrl] C PHASE MODE [>> C
Phas MD]:
Select the phase
rotation mode for
chroma phase control.
The effect of this setting
applies to the output levels
of all of the composite
video, S-video, SDI and
component video signals.
* U/V (COMPOSITE) [>>> Cmpst]: Select this setting when
observing the composite video output level using a
composite vectorscope.
PB/PR (COMPONENT) [>>> Cmpnt]: Select this setting
when observing the component video output level using a
component vectorscope.
ADJ RANGE [>> Adj
range]:
Select the variable
range of the VIDEO
and CHROMA gains.
* –3 to +3 (dB) [>>> –3/+3]:
−3 dB to +3 dB
WIDE [>>> wide]:
−∞ to +3 dB
VIDEO GAIN [>> V gain]:
Adjust the video output
level.
000 [>>> 000] to 3FF [>>> 3FF]
Factory default setting: *200H
CHROMA GAIN [>> C
gain]:
Adjust the chroma
output level.
000 [>>> 000] to 3FF [>>> 3FF]
Factory default setting: *200H
CHROMA PHASE [>> C
phase]:
Adjust the chroma
phase.
00 [>>> 00] to FF [>>> FF]
Factory default setting: *80H
(For DR1000A only)
SETUP LEVEL [>> Setup
lev]:
Adjust the black setup
level.
000 [>>>000] to 3FF [>>> 3FF]
Factory default setting: *200H
(For DR1000A only)
BLACK LEVEL [>> Black
lev]:
Adjust the black level.
000 [>>> 000] to 3FF [>>> 3FF]
Factory default setting: *200H
(For DSR-DR1000AP only)
INPUT BLANK [> Input blnk] LINE 335 [>> Line 335]:
Switch blanking on or
off for the 335th line of
the input video signal.
BLANK [>>> blank]: Blank.
THROUGH [>>> through]: Do not blank.
VIDEO CONTROL [Video]: Settings related to video control Description of settings