Sony DSR-DR1000A - Manual (Page 53)

53
Sending Data
Ch
ap
te
r 5 Net
w
o
rk Op
er
a
tio
ns
Sending Cliplist Data
The following procedure allows you to send the data of
clips in cliplists that have been saved.
1
Select the SEND CLIPLIST item in the Network
menu and press the
k (OUT) button.
The SEND CLIPLIST screen appears, showing the name
of the currently selected host, the name of the target
cliplist, and its duration.
2
If the destination host and clip are correct, proceed to
step 5.
To select the destination host, execute steps 2 to 4 of
“Sending Clip Data” (page 52).
To select the clip list, select LIST in the SEND
CLIPLIST screen and press the
k (OUT) button.
3
Select the cliplist containing the data of the clips that
you want to send, and press the
K (IN) button.
4
You are returned to the SEND CLIPLIST screen,
which displays the number and duration of the
selected cliplist.
5
Press the SET button.
Preparations for communications start.
When the preparations finish, the message “Issuing
transfer request. Will begin transfer after the end of
transfer standby.” appears.
Up to 29 transfer requests can be placed on standby.
When the 30th request is issued, the message
“Request queue full. Cannot send clip.” appears and
the transfer is rejected.
To cancel the transfer
In step 5, press the MENU button instead of the SET
button.
Sending Address Book Data
The following procedure allows you to share address book
data between recorders on the same network by copying
the contents of the address book on one recorder to another
recorder.
1
Select the SEND ADDRESS BOOK item in the
Network menu and press the
k (OUT) button.
The SEND ADDRESS BOOK screen appears, showing
the name of the currently selected host.
>Cliplist NETWORK MENU
SEND
CLIP
CLIPLIST
ADDRESS BOOK
RECEIVE
ADDRESS BOOK
NEW CONTENTS LIST
STATUS
Time counter display
Monitor screen
SEND CLIPLIST
< 01: AAAAAAAA >
HOST: HOST2
LIST: CLIPLIST1
DUR : 0:02:12:20
SEND : SET KEY
TO MENU : MENU KEY
Transfer destination host
a)
Number of cliplist to send b)
Duration of cliplist to send
c)
a) “--------” is displayed when no destination host is selected.
b) “----” is displayed when no cliplist is selected.
c) “0: 00: 00: 00” is displayed when no cliplist is selected.
>Cliplist1 SEND CLIPLIST
LIST
cliplist1
cliplist2
cliplist3
cliplist4
cliplist5
cliplist6
cliplist7
Time counter display
Monitor screen
>Adrs Book NETWORK MENU
SEND
CLIP
CLIPLIST
ADDRES BOOK
Time counter display
Monitor screen