Setting up the remote commander, Step 2, Inserting the batteries – Sony PS User Manual
Page 5: Using the remote commander
Getting Started
5
Getting Started
Step 2
Setting up the remote commander
Inserting the batteries
Insert two R6 (size AA) batteries by
matching the + and – on the batteries to
the diagram inside the battery
compartment.
Using the remote commander
You can use this remote
commander to operate the unit
and a Sony TV. To operate this
unit, point at the remote sensor
on the unit. To operate the TV,
point at the remote sensor on
the TV.
Notes
• With normal use, the batteries should last about three to six months.
• If you do not use the remote commander for an extended period of time, remove
the batteries to avoid possible damage from battery leakage.
• Do not use a new battery with an old one.
• Do not mix different types of batteries.
To
Turn the TV to standby or active mode
Turn on the TV power
Increase (+) or decrease (–) the TV volume
Change the TV programme position
Select an input source of the TV either from aerial in or from line in
Press
u
(on/standby)
;
(TV power)
VOL +/–
PROG (CH) +/–
TV/VIDEO
Remote sensor
;
(TV power)
u
(on/standby)
TV/VIDEO
PROG (CH) +/–
VOL +/–
REC