Sony Cyber-shot DSC-L1 - Manual (Page 15)

15
DSC-L1 2-186-455-11(1) [OpenType FONT]
Getting started Number of images and battery
life that can be recorded/
viewed
The tables show the approximate number
of images and the battery life that can be
recorded/viewed when you shoot images in
normal mode with a fully charged battery
pack (supplied) at a temperature of 25°C
(77°F). The numbers of images that can
be recorded or viewed take into account
changing the “Memory Stick Duo” as
necessary. Note that the actual numbers
may be less than indicated depending on
the conditions of use.
• The battery capacity decreases as the number
of uses increases and over time (page 119).
Shooting still images
Under the average conditions 1)
Image
size
NP-FT1 (supplied)
LCD
backlight
No. of
images
Battery
life (min.)
4M On Approx.
240 Approx.
120
Off Approx.
280 Approx.
140
VGA
(E-Mail) On Approx.
240 Approx.
120
Off Approx.
280 Approx.
140
1) Shooting in the following situations:
– (P.Quality) is set to [Fine]
– Shooting one time every 30 seconds
– The zoom is switched alternately between
the W and T ends
– The flash strobes once every two times
– The power turns on and off once every ten
times
– [AF Mode] is set to [Single] on the Setup
screen
The measurement method is based on CIPA
standard. (CIPA: Camera & Imaging Products
Association)
Viewing still images 2)
Image size
NP-FT1 (supplied)
No. of
images
Battery life
(min.)
4M Approx.
5200 Approx. 260
VGA
(E-Mail) Approx.
5200 Approx. 260
2) Viewing single images in order at about three
second intervals
Shooting movies 3)
NP-FT1 (supplied)
LCD backlight
On
LCD backlight
Off
Approx. 100 min. Approx. 120 min.
3) Shooting movies continuously with the image
size [160]
• The number of images and the battery life that
can be recorded/viewed are decreased under
the following conditions:
– The surrounding temperature is low
– The flash is used
– The camera has been turned on and off many
times
– The zoom is used frequently
– [LCD Backlight] is set to [Bright] on the
Setup screen
– [AF Mode] is set to [Monitor] on the Setup
screen
– The battery power is low