Sony Cyber-shot DSC-L1 - Manual (Page 27)

27
DSC-L1 2-186-455-11(1) [OpenType FONT]
Shooting still images
3
96
VGA
FINE 101
F3.5 30 S AF
60min
AE/AF lock indicator
Flashes green 
Light up
 Press and hold the shutter
button halfway down.
The beep sounds but the image is not yet
recorded. When the AE/AF lock indicator
changes from flashing to steadily lit, the
camera is ready for shooting.
(The LCD screen may be frozen for a split
second depending on the subject.)
• If you release the shutter button, shooting will
be canceled.
• You can continue and shoot even when the
camera does not beep, but in this case the focus
is not set properly.
• No beep sounds when [Beep] is set to [Off] on
the Setup screen (page 113).
4
95
VGA 101
S AF
60min
 Press the shutter button fully
down.
The shutter sounds. The image will be
recorded in the “Memory Stick Duo”.
The recorded image is displayed for
approximately two seconds (Auto Review,
page 112).
• When operating the camera using a battery
pack, if you do not operate the camera for a
while during recording or playback, the camera
turns off automatically to prevent wearing
down the battery (page 17).
Mode switch
When you set the mode switch to ,
the functions that can be used change as
follows according to
(Camera) in the
menu.
Mode
Auto
Camera
Program
Still image auto shooting [Auto]
The focus, exposure and white balance
are automatically adjusted as needed to
allow easy shooting. In addition, the image
quality is set to [Fine] (page 47), the AF
range finder frame is set to [Multi AF], and
the metering mode is set to [Multi] (pages
50 and 55).
Only
(Camera), [Mode] (REC Mode)
and (Setup) appear in the menu.