Additional information, Precautions – Sony ZX6 User Manual

Page 40

Advertising
background image

40

GB

On operating voltage

Before operating the system, check that the operating
voltage of your system is identical with the voltage of
your local power supply.

On safety

• The system is not disconnected from the AC power

source (mains) as long as it is connected to the wall
outlet, even if the system itself has been turned off.

• Unplug the system from the wall outlet (mains) if it

is not to be used for an extended period of time. To
disconnect the power cord (mains lead), pull it out by
the plug. Never pull the cord itself.

• Should any solid object or liquid fall into the system,

unplug the system and have it checked by qualified
personnel before operating it any further.

• For customers in United States

One blade of the plug is wider than other for the
purpose of safety and will fit to the wall outlet only
one way. If you are unable to insert the plug fully into
the outlet, contact your dealer.

• AC power cord must be changed only at the qualified

service shop.

On placement

• Do not place the system in an inclined position.

• Do not place the system in locations where it is:

– Extremely hot or cold

– Dusty or dirty

– Very humid

– Subject to vibrations

– Subject to direct sunlight.

• Use caution when placing the system or speakers on

surfaces that have been specially treated (with wax,
oil, polish, etc.) as staining or discoloration of the
surface may result.

On heat buildup

• Although the system heats up during operation, this

is not a malfunction.

• Place the system in a location with adequate

ventilation to prevent heat buildup in the system.

• If you continuously use this system at a high volume,

the cabinet temperature of the top, side and bottom
rises considerably. To avoid burning yourself, do not
touch the cabinet.

• To prevent a malfunction, do not cover the

ventilation hole for the cooling fan.

On operation

• If the system is brought directly from a cold to a

warm location, or is placed in a very damp room,
moisture may condense on the lens inside the system.
Should this occur, the system will not operate
properly. Remove the disc and leave the system
turned on for about an hour until the moisture
evaporates.

• When you move the system, take out any disc.

If you have any question or problem concerning your
system, please consult your nearest Sony dealer.

Notes on discs

• Before playing, clean the disc with a cleaning cloth.

Wipe the disc from the center out.

• Do not use solvents such as benzene, thinner,

commercially available cleaners or anti-static spray
intended for vinyl LPs.

• Do not expose the disc to direct sunlight or heat

sources such as hot air ducts, nor leave it in a car
parked in direct sunlight.

• Do not use discs encircled with a protection ring.

This may cause a malfunction to the system.

• When using discs that have glue or similar tacky

substance on the label side of the disc or that used a
special ink when the label was printed, there is a
chance that the disc or label may become attached to
parts inside this system. When this occurs, it may not
be possible to remove the disc, and may also cause
this system to malfunction. Be sure to check that the
label side of the disc is not sticky before using.
The following types of disc should not be used:

– Rental or used discs with attached seals where the

glue extends beyond the seal. The perimeter of the
seal on the disc is tacky.

– Discs that have labels printed using a special ink

that feels tacky when touched.

• Discs with non-standard shapes (e.g., heart, square,

star) cannot be played on this system. Attempting to
do so may damage the system. Do not use such discs.

Additional Information

Precautions

Advertising
This manual is related to the following products: