Sony ZX6 - Manual (Page 29)

Displa
y
29 GB
7
Press DIRECTION repeatedly to select
“
g ” to record on one side. Select
“ j ” (or “RELAY”) to record on both
sides.
If you want to record on the reverse side,
press h (TAPE B). Then, press x
(TAPE B).
When you record on both sides, be sure to
start from the front side. If you start from
the reverse side, recording stops at the end
of the reverse side.
8
Press ?/1 to turn off the system.
When the recording starts, the volume level
is set to minimum.
Other operations
Notes
• You cannot select the Play Timer and Timer
Recording at the same time.
• If you use the Timer Recording and Sleep Timer at
the same time, the Sleep Timer has priority.
• The Timer Recording will not activated if the system
is on.
• Do not operate the system from the time the system
turns on until the recording starts (about 15 seconds
before preset time).
Tips
• The system turns on 15 seconds before the preset
time.
• When the Timer Recording is selected, the “REC”
lights up in the display.
The demonstration display and the clock display
can be turned off to minimize the amount of
power consumed during standby mode (Power
Saving Mode).
Press DISPLAY repeatedly while the
system is turned off until the
demonstration display and the clock
display disappears.
To cancel Power Saving Mode
Press DISPLAY once to show the
demonstration display or twice to show the
clock display. Each time you press the button,
the display changes cyclically as follows:
Demonstration display
1) t Clock display 2) t
Power Saving Mode
1) The display changes and the indicators flashes even
when the system is turned off.
2) “--.--” appears in the display if you have not set the
clock.
Note
You cannot do the following operations in Power
Saving Mode.
– setting the clock (page 11)
– changing the AM tuning interval (page 17)
– turning on the system by pressing the following
buttons
(a) TUNER/BAND
(b) GAME
(c) h/H (TAPE A)
(d) h/H (TAPE B)
(e) NX (CD)
(f) CD on the remote
(g) TAPE on the remote
– changing “CD POWER” settings (page 17)
– switching the VIDEO/MD function (page 34)
Tips
• The timer continues to operate in Power Saving
Mode.
• The ?/1 indicator lights up even in Power Saving
Mode.
To Do this
Check the setting 1 Press CLOCK/TIMER
SELECT.
2 Press M or m (or >+ or
–. on the remote)
repeatedly until “REC
SELECT?” flashes in the
display, then press ENTER.
Change the setting Start from step 1.
Cancel the timer 1 Press CLOCK/TIMER
SELECT.
2 Press M or m (or >+ or
–. on the remote)
repeatedly until “TIMER
OFF?” flashes in the display,
then press ENTER.
Display
Turning off the display
— Power Saving Mode