Sharp VL-Z1U - Manual (Page 21)

7
Preparation
Charging the Battery
Pack
1
Attach the battery pack on the
camcorder, and make sure that the
Power switch is set to OFF.
2
Open the DC IN jack cover.
3
Insert the DC plug into the DC IN
jack of the camcorder (1), and plug
the AC plug into a power outlet (2).
• The POWER/CHARGE (RED)
indicator lights up red.
• The POWER/CHARGE (RED)
indicator turns off when the battery is
charged.
4
Remove the DC plug from the DC IN
jack, then remove the AC adapter
from the power outlet.
• The chart specifies the approximate times in
minutes.
Notes:
• Charge the battery pack between 50°F and
86°F (10°C and 30°C). The battery pack
may not charge properly at temperatures
too low or too high.
• The battery pack and AC adapter become
warm during charging. This is not a
malfunction.
• Using the zoom (see page 20) and other
functions or turning the power on and off
frequently will increase power consump-
tion. This may result in a decrease in the
actual recording time compared to the
maximum continuous recording time listed
above.
• The charging time and recording time may
vary depending on the ambient tempera-
ture and the condition of the battery pack.
• See pages 67 and 68 for more information on
using the battery pack.
• Charge only SHARP model BT-L226 battery
packs. Other types of battery packs may
burst, causing personal injury and damage.
• When attaching the supplied audio/video/S-
video cable, remove the DC plug, open the
terminal cover and connect it.
BT-L226
Charging
time
Battery
pack
Max.
continuous
recording time
Max.
continuous
playback time
on LCD
120 120 105
Charging time and maximum
continuous recording and playback
times
LCD
closed
LCD
open
105
DC IN jack cover
DC plug
To power outlet
DC IN jack
AC plug
POWER/CHARGE (RED)
indicator