Seiko Group SII IP-6600 - Manual (Page 51)

2-7
Section 2 Basic Operations
Booting
PRINT READY
ROLL : 64” (PAPER)
INITIALIZING
WAIT A MOMENT
NOTE
- Turn OFF the printer while “PRINT READY” is displayed on
the LCD panel except emergency.
Do not turn OFF the printer while “INITIALIZING” or
“CLEANING” is displayed on the LCD panel to avoid drop of
the ink and damage of the head.
Turning the Power On/Off
If a 64" paper roll is used
The heater control panel is displayed by turning the printer power ON.
However, turn the heater power ON to use the heater.
When the heater power is turned OFF, the following message is displayed
on the heater control panel.
TURN ON
THE HEATER
- If the fan does not run or the operation panel lamp does not
light when the printer switch and power ON/OFF switch on
the operational panel are turned ON, the power supply may
be faulty.
- If an error is detected during the self-diagnostic test at
powering on, an error message appears on the LCD. See
the Section 5, Troubleshooting and take an appropriate
measure.
HINT
When the switch is turned ON, a power-on self-diagnostic test is performed
and the following message appears on the LCD on the operation panel.