Sony RDR-GX3 - Manual (Page 21)

21
Step 5: Connecting the Mains Lead
Basic H
o
ok
ups and Set
tings
Connecting to an AV amplifier
(receiver) with a digital input jack and
6 speakers
If your AV amplifier (receiver) has a Dolby Digital, MPEG
audio, or DTS decoder and a digital input jack, use this
connection. Note that the surround sound effects of this recorder
cannot be used with this connection.
z Hint
For correct speaker location, see the operating instructions of the
connected components.
Note
After you have completed the connection, be sure to set “Dolby Digital”
to “Dolby Digital” and “DTS” to “On” under “Audio” in Easy Setup
(page 22). If your AV amplifier (receiver) has an MPEG audio decoder
function, set “MPEG” in “Audio” to “MPEG.” Otherwise, no sound or a
loud noise will come from your speakers.
Step 5: Connecting the
Mains Lead
Connect the supplied mains lead to the AC IN terminal of the
recorder. Then plug the recorder and TV mains leads (power
cords) into the mains. After you connect the mains lead, you
must wait for a short while before operating the recorder.
You can operate the recorder once the front panel display lights
up and the recorder enters standby mode.
If you connect additional equipment to this recorder (page 27 to
28), be sure to connect the mains lead after all connections are
complete.
D
~ AC IN
LINE 2 OUT
S VIDEO VIDEO R-AUDIO-L
COMPONENT VIDEO OUT
CB
Y
CR
LINE 4 IN
S VIDEO VIDEO R-AUDIO-L
LINE 1 - TV AERIAL
IN
OUT
LINE 3/DECODER
DIGITAL OUT PCM/DTS/MPEG/ DOLBY DIGITAL
COAXIAL
DIGITAL OUT
PCM/DTS/MPEG/
DOLBY DIGITAL
COAXIAL
D
DVD recorder
to DIGITAL OUT
(COAXIAL)
Coaxial digital cord
(not supplied)
to coaxial digital input
[Speakers] [Speakers]
Rear (L)
Rear (R)
Subwoofer Front (L)
Front (R)
Centre
AV amplifier
(receiver) having a
decoder
: Signal flow
~ AC IN
mains lead
to AC IN