Sony Security Camera - Manual (Page 20)

Initial Operations (Basic Initial Setup)
20
3
Perform the following settings.
In the Camera IP Setup window, you can search for
cameras on the same network by MAC address and
configure their IP addresses all at once.
(1) Select the network to search in the field labeled
“1. Select Network Device for IP Setup.”
Normally, Network 1 is selected as the camera
network, and a list of the cameras found appears
in the “Found Camera List.” The check boxes of
all found cameras are selected.
(2) Enter the following information in the field
labeled “2. Set Camera network setting.”
• The user name and password of the camera
you are configuring settings for.
• The range of IP addresses on the same
network (default: 0 to 254) for which to
perform automatic assignment.
• The http port number (default: 80) for
communicating with cameras.
* If there is a fixed range of IP addresses that
can be assigned to cameras, make sure to
specify the correct range.
(3) Click [Set].
The information you entered is reflected in the
“Found Camera List.”
IP addresses are assigned within the specified
range. Because the list does not expand to
compensate if there are not enough IP
addresses, make sure the list is set correctly by
directly changing addresses in the list as needed.
At this stage, the settings have not yet been
applied to the camera.
(4) Click [Apply].
This configures the camera settings using the
information developed in the list.
It takes a few moments for the settings to
complete.
4
When the settings for each camera are complete,
click [Register All].
The Register Cameras window appears.
5
Perform the following settings.
In the Register Cameras window, a list of cameras
that have not been registered to the NSR appears
with the check box for each selected.
(1) Verify the number of cameras selected for
registration in the column labeled “Cameras to
be registered”, and confirm the user name and
password for each camera.
Note
The user name and password for the cameras are
not set by default. You can set the user name and
password for the selected cameras all at once
under “Register selected Cameras for NSR”.
(2) Click [Register].
The selected cameras are registered to the NSR.
* By clicking [Camera IP Setup], you can also
return to the previous Camera IP Setup
window.
6
When registration is complete, click [Close].
The Configuration window returns to the Camera
screen. The registered cameras are listed.
7
If necessary, configure the individual settings for
each camera.
For details about settings, refer to the supplied
user’s guide.