Installing and removing doors (cont.) – SharkRack 45U User Manual
Page 16
Advertising
SharkRack Enclosure Installation Guide
ID-00210-000
REV D, ECO2773
Page 16 of 46
Installing and Removing Doors (cont.)
Step Detail
To install doors:
1. Align the lower door hinge pin with the hole in
the bottom hinge bracket and slide the hinge pin
into the hole.
2. Pull down the upper hinge pin.
3. Align the upper hinge pin with the hole in the
upper hinge bracket and release the hinge pin
into the hole.
4. Make sure the door opens and closes properly.
CAUTION: Ensure that hinge pins are
secured into the hinge brackets. If not
properly installed the door may
unexpectedly fall.
Figure 13
42U X 37DP Shown
Advertising