Sony DSX-S310BTX - Manual (Page 32)

32
Bluetooth (Handsfree calling
and Music streaming)
Bluetooth Operations
To use the Bluetooth function, the following
procedure is necessary.
1 Pairing
When connecting Bluetooth devices for the
first time, mutual registration is required. This
is called “pairing.” This registration (pairing)
is required only for the first time, as this unit
and other devices will recognize each other
automatically from the next time. You can
pair with up to 9 devices.
2 Connecting
After pairing is made, connect this unit and
the Bluetooth device. Depending on the
device, connection automatically made along
with the pairing.
3 Handsfree calling/Music streaming
You can make/receive a handsfree call, or
listen to audio through this unit.
For details of usable devices, visit the following
support site.
About Bluetooth icons
The following icons are used by this unit.
* Turns gray without handsfree connection. Differs in
the case of a cellular phone.
Installing the microphone
To capture your voice during handsfree calling,
you need to install the microphone (supplied).
For details on how to connect the microphone,
refer to the supplied “Installation/Connections”
guide.
Pairing
First, register (“pair”) a Bluetooth device
(cellular phone, etc.) and this unit with each
other. You can pair up to 9 devices. Once pairing
is established, there is no need for pairing again.
1
Press and hold (BLUETOOTH).
“
” flashes (pairing is in standby mode).
2
Set the Bluetooth device to search for
this unit.
A list of detected devices appears in the
display of the device to be connected. This
unit is displayed as “Sony Automotive” on
the device to be connected.
3
If passkey* input is required on the
display of the device to be connected,
input “0000.”
This unit and the Bluetooth device memorize
each other’s information, and when pairing is
made, this unit is ready for connection to the
device.
Lit:
Flashing:
None: Bluetooth signal is on.
Pairing is in standby mode.
Bluetooth signal is off.
Lit:
Flashing:
None:
Connected to a cellular
phone.
Connection is in progress.
No cellular phone is
connected for handsfree
calling.
Lit:
Flashing:
None: Connected to a device.
Connection is in progress.
No device is connected for
music streaming.
Lit:
Flashing:
None:
Some unread SMS
messages exist.
A new SMS message has
been received.
No unread SMS messages
exist.
Support site
http://esupport.sony.com
http://www.sony.com/mobileAV
Signal strength status of
connected cellular phone.*
Remaining battery status of
connected cellular phone.*
XXXXXXX
DR-BT30Q
Sony
Automotive
XXXX
Input passkey.
“0000”