Sharp Aquos LC 26D5U - Manual (Page 93)

92
Appendix
• LISTINGS disappeared after a
power failure.
• Some channel numbers in the TV
Guide On Screen are incorrect.
• You have not received any local
program listings.
• A program you set to record did
not record.
• The TV did not tune to a program
you scheduled with the reminder
feature.
• You set a program to "auto tune
TV" and it did not.
• You set a program with the "power
on TV" option and it did not.
Problem Possible Solution
• You should begin to receive listings again within 24 hours.
• You can correct them using "Changing channel display" under SETUP.
Listings usually appear within 24 hours after a successful Setup.
• Check the connections between the TV, cable, antenna, and the G-LINK cable if
using a cable box.
• Verify Setup information under "Changing system settings".
• Make sure the cable box is on, if applicable.
• Review step 4 and step 5 of "Basic Initial Setup" on page 21.
• Make sure your recorder is turned off before the recording begins.
• Make sure there is free space available for recording on the tape or recording
device.
• Check the SCHEDULE menu and verify that the program is listed, before
recording begins.
• Check the placement of the G-LINK cable in front of your recorder.
• Check the SCHEDULE menu and verify that the program is listed.
• If you have a cable box, check the G-LINK cable.
• Check the SCHEDULE menu and verify that the program is listed as a Reminder.
• Highlight the program under LISTINGS and do the following:
- Press MENU on the remote control.
- Use b to highlight "edit reminder", and press ENTER.
- Verify the "auto tune TV" option reads "yes".
• The TV must be on at the scheduled time for "auto tune TV".
• Check the SCHEDULE menu and verify that the program is listed as a Reminder.
• Highlight the program under LISTINGS and do the following:
- Press MENU on the remote control.
- Use b to highlight "edit reminder", and press ENTER.
- Verify that the "power on TV" option reads "yes".
• The TV must be off at the scheduled time for "power on TV".
Troubleshooting-TV Guide On Screen