3 – cassette operations, Playback operations, Continuous tape/cd playback – Sony CC-222 User Manual

Page 15: 3, “cassette operations

Advertising
background image

TASCAM CC-222 Owner’s Manual

15

3 – Cassette operations

Note the following when loading tapes:

1

Use your finger or a pencil to turn the cas-
sette's hub and take up any slack tape.

NOTE

Avoid touching the tape. Fingerprints attract dust and
dirt.

2

Press the

EJECT

key to open the cassette

compartment door.

3

Load the cassette tape with its open edge fac-
ing down.

4

Gently close the compartment door.

NOTE

*Notes:

The cassette holder cannot be opened during recording
or playback.

If the power has been switched off during play or
recording, ejecting the cassette may be impossible. In
such a case, switch the power on and press the
EJECT
key again.

Playback operations

1

With the power on, set the

REV MODE

switch

to the required tape mode.

2

Load a pre-recorded cassette with its open
edge facing down and side A facing toward
you.

3

Set the Dolby NR system on or off.

4

Press either

PLAY

key to start playback.

5

Adjust the volume with the amplifier's vol-
ume control.

6

To stop playback, press the

STOP

key.

Continuous tape/CD playback

1

Load the tape (as described above) to be
played back into the unit. Load the disc (use
the

OPEN/CLOSE

key and load the disc

recorded side downwards and close the tray).

2

Press the

CD-TAPE CONT PLAY

key.

3

Press either of the

PLAY

keys of the tape

deck, or the

PLAY

key of the CD deck.

Playback will start on the appropriate unit.
When playback reaches the end of the disc,
or the end of the tape (either one side or two

sides, as determined by the

REV MODE

set-

ting), playback starts on the other unit.

Media (tape or disc) can be changed in the unit that is
not playing.

NOTE

The cassette deck and CD deck can be used to play back
through different outputs, or the
LINE OUTPUTS 2
jacks can be used for both disc and tape playback. How-
ever, note that if both are playing, the cassette takes
priority (the disc will not be heard through these out-
puts). Disc playback is always through the
LINE
OUTPUTS 1

jacks.

u

Single-sided playback

j

One side, then the other side, then stop

p

One side, then the other side, then the first side again,
etc.

Advertising