Sony MZ-R910 - Manual (Page 108)

108
MZ-R910.3-234-699-01(1)
On the remote control
1 Follow steps 1 and 2 of “On the remote
control” in “Relabeling recordings”
(page 107) and display the track, group,
or disc name that contains the phrase
that you want to store.
2 Pull and turn the control towards VOL +
or VOL – to move the cursor to the right
of the phrase.
3 Press X for 2 seconds or more to store
the phrase.
Entering and storing phrases
On the recorder
1 Press the jog dial.
2 Turn the dial until “EDIT” flashes in the
display, and then press to enter.
3 Turn the jog dial until “Name Bank”
flashes in the display, and then press to
enter.
4 Follow steps 5 to 8 of “Labeling
recordings” (page 106) to enter a phrase.
“Entry!” appears in the display and the
phrase is stored.
On the remote control
1 Press DISPLAY for 2 seconds or more.
2 Turn the control repeatedly until “EDIT”
flashes in the display, and press x to enter.
3 Turn the control repeatedly until “Name
Bank” flashes in the display, and then
press x to enter.
4 Do steps 5 to 7 of “On the remote control”
in “Labeling recordings” (pages 106 and
107) to enter a phrase.
Note
If you have entered and then stored a phrase,
you cannot retrieve it by following the
procedure of “Searching a phrase by
displaying the stored phrase one by one”.
When you retrieve a stored phrase, follow the
procedure of “Searching for a phrase by its
first letter.”
Using a retrieved phrase for
labeling
There are two ways to retrieving phrases
for labeling.
• Searching for a phrase by displaying
the stored phrase:
You can retrieve a phrase by keyword,
and then use the phrase in a new label.
• Storing phrases from a previously
labeled track, group, or disc:
You can store an existing track, group,
or disc name as a phrase.
• Inputting and storing phrases:
You can store frequently used phrases in
advance, and then retrieve and use them
when labeling a track, group, or disc.
Storing phrases while labeling a
track or disc
On the recorder
1 Follow steps 1 to 7 of “Labeling
recordings” (pages 105 and 106) to enter
a phrase.
2 After entering the phrase, press
CANCEL to remove the cursor from the
character palette to the letter input area.
3 Press END SEARCH for 2 seconds or
more.
“Entry!” appears in the display and the
cursor flashes after the phrase you just
stored.
4 If you continue labeling operation, do
steps 5 to 8 of “Labeling recordings”
(page 106).
On the remote control
1 Follow steps 1 to 6 of “On the remote
control” (pages 106 and 107) in
“Labeling recordings” to enter a phrase.
2 After entering the phrase, press X for 2
seconds or more.
3 If you continue labeling operation, do
steps 5 to 7 of “On the remote control”
(pages 106 and 107) in “Labeling
recordings”.
Storing phrases from a previously
labeled track, group, or disc
On the recorder
1 Follow steps 1 and 2 of “Relabeling
recordings” (page 107) and display the
track, group, or disc name that contains
the phrase that you want to store.
2 Press ./> repeatedly to move the
cursor to the right of the phrase.
3 Press END SEARCH for 2 seconds or
more to store the phrase.
02.4.30, 11:34 AM 108