Sony SRX- R110 - Manual (Page 12)

GB 12
Location and Function of Controls
Ch
apt
er 1 Ov
e
rv
ie
w
B: Selects the signal input from the connectors on the
optional input board installed in the INPUT B section.
C: Selects the signal input from the connectors on the
optional input board installed in the INPUT C section.
D: Selects the signal input from the connectors on the
optional input board installed in the INPUT D section.
Use these buttons together with the PICTURE CONT
buttons (
6) or SCREEN SEL buttons (7).
Example: When you want to increase the contrast of the
signal input from the INPUT A board, press INPUT
SEL A button, then press the CONTR + button.
f PICTURE CONT (Picture control) buttons
Adjust the projected picture quality.
CONTR+/–: Adjust the contrast. Pressing the + button
increases the contrast. Pressing the – button decreases
the contrast.
BRIGHT +/–: Adjust the picture brightness. Pressing the
+ button makes the picture brighter. Pressing the –
button makes the picture darker.
SHARP +/–: Adjust the picture sharpness. Pressing the +
button makes the picture sharper. Pressing the –
button makes the picture softer.
In multiple screen mode, adjustment can be made for the
input signal from each input board.
Select the input signal with the INPUT SEL A/B/C/D
buttons (
5), then adjust the picture with these buttons. In
single-screen mode, you need not press the INPUT SEL
button.
Example: When you want to increase the contrast for the
signal input from the INPUT A board, press the
INPUT SEL A button, then press the CONTR +
button.
g SCREEN SEL buttons
In multiple screen mode, select one of the divided screens
where you want to project the selected signal from each
input board.
Select the input signal with one of the INPUT SEL A/B/C/
D buttons (
5), then select the screen with one of these
buttons.
Example: When you want to project the signal input from
the INPUT B board on Screen 3 (lower left screen),
press the INPUT SEL B button, then press the
SCREEN SEL 3 button.
h LENS CONT buttons
FOCUS +/–: Adjust the focus. Pressing the + button
focuses on a forward picture. Pressing the – button
focuses on a picture further back.
ZOOM +/–: Adjust the picture size. Pressing the + button
enlarges the picture size. Pressing the – button
reduces the picture size.
SHIFT +/–: Adjust the vertical picture position. Pressing
the + button moves the picture upward. Pressing the –
button moves the picture downward.
To install batteries
1
Remove the lid, then install the two size AA (R6)
batteries (supplied) with the correct polarity.
2
Replace the lid.
• Be sure that there is nothing to obstruct the infrared
beam between the Remote Commander and the
projector. Direct the Remote Commander toward one of
the remote control detectors at the front and rear of the
projector when operating.
• The operation range is limited. The shorter the distance
between the Remote Commander and the projector, the
wider the angle within which the Commander can
control the projector.
Notes
Push the knob to open
the lid. Be sure to install the battery
from the – side.