Sony SRX- R110 - Manual (Page 17)

17 GB
Connecting a Computer for Controlling the Projector
Cha
pt
er 2
P
repa
rati
ons
Connecting a Computer
for Controlling the
Projector
Connect a computer for controlling the projector to the
projector via the ETHERNET connector or the RS232C
connector.
Connecting the Computer via the
Ethernet
Connect the computer to the projector using the supplied
ethernet cable (cross cable).
Set the TCP/IP protocol of the connected computer to
DHCP.
For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port. Follow the instructions for this port.
Par mesure de sécurité, ne branchez pas le connecteur d’un
périphérique ayant une tension excessive à ce port. Suivez
les instructions pour ce port.
Schließen Sie das Kabel aus Sicherheitsgründen nicht an
eine Buchse für Peripheriegeräteanschluss an, die eine zu
hohe Spannung aufweisen könnte. Befolgen Sie die
Anweisungen für diesen Anschluss.
If the power of the projector remains on for a long period
of time without the Ethernet cable connected, the message
“Sony SR Projector Initializing…” may appear in the
STATUS MESSAGE window while you are setting up for
networking after connecting the Ethernet cable. This is not
a malfunction of the projector.
Connecting the Computer via the
RS-232C
Note
CAUTION
R(Pr/Cr) B(Pb/Cb) HD VD G(Y/Y)
R(Pr/Cr) B(Pb/Cb) HD VD G(Y/Y)
IN
INTER LOCK ETHERNET RS232C
OUT
IN OUT
ETHERNET connector
Ethernet cable (cross cable)
(supplied)
Computer
Ethernet connector
ATTENTION
VORSICHT
Note
INTER LOCK ETHERNET RS232C
R(Pr/Cr) B(Pb/Cb) HD VD G(Y/Y)
R(Pr/Cr) B(Pb/Cb) HD VD G(Y/Y)
IN OUT
IN OUT
RS232C connector
Connecting cable (not supplied)
Computer
RS-232C connector