Swann 4 CH Digital Video Recorder - Manual (Page 15)

14
(PIP)
FULL SCREEN CAM 1
PIP SCREEN CAM 2
POSITION D/R
(DWELL)
NORM ALARM
CAM1 01 01
CAM2 01 01
CAM3 01 01
CAM4 01 01
4. QUALITY
There are four quality settings during an
ALARM : BASIC, BEST, HIGH, NORMAL.
5. RECORD MODE
There are three recording settings : QUAD-FRAME, QUAD-FIELD,
MULTIPLEX.
DWELL
1. NORM
To set up the DWELL time period that each channel auto sequentially shows on call
monitor. The level is from 1 to 15 SEC or OFF.
2. ALARM
To set up the DWELL time period when alarm input is triggered.
The level is from 1 to 15 SEC or OFF.
(MENU)
TIMER
CAMERA
RECORD
ALARM
DWELL
PIP
MOTION
DISPLAY
REMOTE
USER
SYSTEM
EVENT
PIP
1. FULL SCREEN
To set up the full screen background picture display.
2. PIP SCREEN
To set up the picture with a 1/9 size screen “insert”.
3. POSITION
There are six position settings : D/L, D/M, D/R, U/L, U/M, U/R.
(MENU)
TIMER
CAMERA
RECORD
ALARM
DWELL
PIP
MOTION
DISPLAY
REMOTE
USER
SYSTEM
EVENT
MOTION
1. SEN (SENSITIVITY)
Sets the sensitivity of the pixel-based Motion Detection feature from 1fo 99.
The highest sensitivity setting is 01, the lowest sensitivity setting is 99.
The default setting is 70.
2. MD-NUM (MOTION DETECTION NUMBER)
Sets the number of targets in which Motion must occur in order to trigger an Alarm
(from 1-99 target areas).
Note : MD-NUM cannot be less than the number of targets set in the AREA.
3. RE (REFERENCE)
Set the Reference image to which the current screen is compared (from 1-99).
For example, the value 64 would compare the current image to the 64 th previous
screen image. The higher value may increase the sensitivity.
4. DET (DETECTION)
The motion detection on each channel can be turned to
ON or OFF individually.
(MENU)
TIMER
CAMERA
RECORD
ALARM
DWELL
PIP
MOTION
DISPLAY
REMOTE
USER
SYSTEM
EVENT