Sony WEGA KV-29FQ76 K - Manual (Page 74)

24 Additional Information
Specifications
TV System
B/G/H, D/K
Colour System
PAL
NTSC 3.58, 4.43 (only Video In)
Channel Coverage
VHF:
E2 - E12
UHF: E21 - E69
CATV: S1 - S20
HYPER: S21 - S41
D/K: R1 - R12, R21 - R69
Picture Tube
FD Trinitron Approx. 72cm (29 inches)
Sound Output
Left/Right:
2x20W (music power)
2x10W (RMS)
Power Consumption
143W
Dimensions (w x h x d)
Approx. 850 x 600 x 555mm
Weight
Approx. 54kg
Rear Terminals
21-pin Euro connector (CENELEC standard) including audio/
video input, RGB input, TV audio/video output.
DVD 21-pin Euro connector (CENELEC standard) including audio/
video input, RGB input, TV audio/video output.
(SMARTLINK) VCR 21-pin Euro connector (CENELEC standard) including audio/
video input, S-video input, selectable audio/video output.
21-pin Euro connector (CENELEC standard) including audio/
video input, S-video input.
RF In
Audio output - phono jacks
Side Terminals
Video input - phono jack
Audio inputs - phono jacks
S video input - 4 pin DIN
Headphones jack - minijack stereo
Accessories Supplied
RM-938 remote control (1)
IEC designated size AA (R6) battery (2)
1
2
3/ s 3
4/ s 4
5
5
s 5
Design and specifications are subject to change without notice.
Troubleshooting
Here are some simple solutions to problems which may affect the picture and sound.
Problem Suggested Remedy
No picture (screen is dark), no sound. • Plug the TV in.
• Press the button on the front of the TV.
• If the indicator on the TV is lit press the TV button or a numbered
button on the remote control.
• Check the aerial connection.
• Turn the TV off for 3 or 4 seconds and then turn it on again using the
button on the front of the TV.
Poor or no picture (screen is dark), but good sound. • Using the MENU system, select the Picture Adjustment menu. Adjust
the brightness, picture and colour balance levels.
• From the Picture Adjustment menu select RESET to return to the
factory settings.
Good picture, no sound. • Press the button on the remote control.
• If is displayed on the screen, press the button on the remote
control.
No colour on colour programmes. • Using the MENU system, select the Picture Adjustment menu and
adjust the colour setting.
• From the Picture Adjustment menu select RESET to return to the
factory settings.
Distorted picture when changing channels or selecting Text. • Turn off any equipment connected to the scart connectors on the rear of
the TV.
Remote control does not function. • Check that the b MODE B Selector button on the remote control is set
according to the device you are using (VCR, DVD or TV).
• If the remote control does not operate your VCR or DVD even when the
b MODE B Selector button has been set correctly, refer to the ‘Remote
control of other equipment’ section of this instruction manual and enter
the correct code.
• Replace the batteries.
Interference on picture from connected equipment. • Reduce sharpness level.
The standby indicator on the TV flashes. • Contact your nearest Sony service centre.
/
• If you continue to have these problems, have your TV serviced by qualified personnel.
• NEVER open the casing yourself.
29FQ76 B5 Part 6 GB.fm Page 24 Tuesday, May 7, 2002 11:56 AM