Sony DAV-HDX589W - Manual (Page 77)

Contr
o
l f
o
r HDMI/
Extern
al A
u
dio
D
e
vic
e
77 US
• To set the ID of the surround amplifier,
see “To set the ID of the surround
amplifier” (page 74).
• To set the ID of the S-AIR receiver, refer
to the operating instructions of the S-AIR
receiver.
3
Press SYSTEM MENU.
4
Press X/x repeatedly until “PAIRING”
appears in the front panel display, then
press
or c.
5
After “START” appears in the front
panel display, press
.
The unit starts pairing and “SEARCH”
flashes in the front panel display.
To cancel pairing, press SYSTEM MENU.
6
Start pairing of the S-AIR sub unit.
x For the surround amplifier
Press POWER on the surround amplifier to
turn on the surround amplifier and press
PAIRING on the rear panel of the surround
amplifier.
The PAIRING indicator of the surround
amplifier flashes red when pairing starts.
When sound transmission is established,
the PAIRING indicator of the surround
amplifier turns red and “PAIRING” and
“COMPLETE” appear alternately in the
front panel display.
Tip
• To press PAIRING on the rear panel of the
surround amplifier, a slim instrument, such as a
paper clip, can be used.
x For the S-AIR receiver
Refer to the operating instructions of the
S-AIR receiver.
When sound transmission is established,
“PAIRING” and “COMPLETE” appear
alternately in the front panel display.
Note
• Perform pairing within several minutes of Step
5. If you do not, “PAIRING” and
“INCOMPLETE” appear alternately in the front
panel display. To continue pairing, press
and
start again from Step 5. To cancel pairing, press
SYSTEM MENU.
7
Press SYSTEM MENU.
The system menu turns off.
Note
• After you have performed pairing, if you select
“S-AIR ID” (page 76), the ID setting (“A,” “B,” or
“C”) that you last used is displayed first by default.
To cancel pairing
Perform the ID setting of the unit according to
the procedure of “To set the ID of the unit.” If
you select a new ID, pairing is canceled.
If you use multiple wireless systems which share
the 2.4 GHz band, such as wireless LAN or
Bluetooth, the transmission of S-AIR products
or other wireless systems may be unstable. In
this case, the transmission may be improved by
changing the following “RF CHANGE” setting.
1
Press SYSTEM MENU.
2
Press X/x repeatedly until “RF
CHANGE” appears in the front panel
display, then press
or c.
3
Press X/x to select the desired setting.
• “AUTO”: Normally select this. The
system changes “RF CHANGE” to “ON”
or “OFF” automatically.
• “ON”: The system transmits sound by
searching for the better channel for
transmitting.
• “OFF”: The system transmits sound by
fixing the channel for transmitting.
4
Press .
The setting is made.
5
Press SYSTEM MENU.
The system menu turns off.
6
When you set “RF CHANGE” to “OFF,”
select the ID so that sound
transmission is most stable (page 74).
Note
• In most cases, you will not need to change this
setting.
If sound transmission is
unstable
For the surround amplifier
For the S-AIR receiver