Sharp MX-2700N - Manual (Page 36)

35
• Before inserting originals into the document feeder tray, be sure to remove any staples or paper clips.
• If originals have damp spots due to correction fluid, ink or pasteup glue, wait until the originals are dry before making
copies. Otherwise the interior of the document feeder or the document glass may be soiled.
• Do not use the following originals. Incorrect original size detection, original misfeeds, and smudges may result.
Transparency film, tracing paper, carbon paper, thermal paper or
originals printed with thermal transfer ink ribbon should not be fed
through the document feeder. Originals to be fed through the
feeder should not be damaged, crumpled, folded, loosely pasted
together, or have cut-out holes. Originals with multiple punched
holes other than two-hole or three-hole punched paper may not
feed correctly.
• When using originals with two or three holes, place them so that the
punched edge is at a position away from the feed slot.
Hole
positions Feed slot