Sharp MX-2700N - Manual (Page 31)

30
IMPORTANT POINTS WHEN USING THE BYPASS TRAY
• When using plain paper other than SHARP standard paper or special types of paper other than
SHARP-recommended transparency film, or are printing on the reverse side of previously used paper, the paper must
be loaded one sheet at a time. Loading more than one sheet at a time will cause misfeeds.
• Before loading paper, straighten any curling in the paper.
• When adding paper, remove any paper remaining in the tray, combine it with the paper to be added, and reload as a
single stack. If paper is added without removing the remaining paper, a misfeed may result.
• When using glossy paper, set the paper type to [Heavy Paper]. This will bring out the glossy quality of the paper.
Inserting paper
Inserting tab paper
When copying on tab paper, orient the paper so that the side with the tabs enters the machine last. The bottom side of
the inserted paper will be printed on.
Place the tab paper and original as shown below.
When copying onto tab paper, insert the tab paper with the side to be copied on face down in the bypass tray.
8
Select the bypass tray.
(1) Touch the paper size key of the bypass tray.
(2) Touch the [OK] key.
Do not place heavy objects on the bypass tray or press down on the tray.
A5, 7-1/4" x 10-1/2" or less size paper must be inserted in the horizontal
orientation as shown at left.
Original Tab paper Copy
Automatic document feeder Document glass
Use only tab paper that is made of paper. Tab sheets made of film or other material cannot be used.
OK OK
Plain
Plain
Plain
Plain
Recycled
Paper Select
A4 A4
A4R
B4
A3
(2) (1)
1
2
3
4
5
Paper feed
direction
1
2
3
4
5
Leading edge
of original 1
2
3
4
5
Face down