Sharp MX-2700N - Manual (Page 46)

45
SADDLE STITCH FINISHER
The saddle stitch finisher is equipped with the offset function that offsets each set of output from the previous set, the
staple sort function that staples each set of output, and the saddle stitch function that automatically staples and folds
each set of output at the centreline.
An optional hole punching unit can also be installed to punch holes in output.
PART NAMES
(1) Stapler compiler
This temporarily stacks paper to be stapled.
(2) Output tray
Stapled and offset output is delivered to this tray.
The tray is slidable. Extend the tray for large output
(A3W, A3, B4, 12" x18", 11" x 17", 8-1/2" x 14" and
8-1/2" x 13" sizes).
(3) Saddle stitch tray
Stapled and folded output is delivered to this tray.
(4) Top cover
Open this cover to remove a paper misfeed.
(5) Lever
To remove a staple jam or paper misfeed, pull this lever
and slide the saddle stitch finisher to the left until it stops.
(6) Stapler section
Open the front cover and pull out this section to replace
the staple cartridge or remove a staple jam.
(7) Front cover
Open this cover to replace the staple cartridge or remove
a staple jam.
SUPPLIES
The saddle stitch finisher requires the following staple cartridge:
• Staple cartridge
(approx. 5000 staples per cartridge x 3 cartridges)
AR-SC2
(1)
(2)
(3)
(4)
(6)
(5)
(7)
• A paper pass unit is required to install a saddle stitch finisher.
• Do not place heavy objects on the saddle stitch finisher or press down on the saddle stitch finisher.
• Use caution when you turn on the power and when printing is taking place, as the tray may move up and down.
• A saddle stitch finisher and a finisher cannot be installed simultaneously.