Interior, Caution – Sharp MX-2700N User Manual
Page 7
6
INTERIOR
(15) Toner cartridges
When the toner in a cartridge runs out, the cartridge must
be replaced with a new cartridge of the same colour.
☞
REPLACING THE TONER CARTRIDGES
(page 58)
(16) Fusing area
Heat is applied here to fuse the transferred image onto
the paper.
(17) Transfer belt
During full colour copying, the toner images of each of
the four colours on each of the photoconductive drums
are combined together on the transfer belt.
During black and white copying, only the black toner
image is transferred onto the transfer belt.
(18) Right side cover
Open this cover to operate the fusing area pressure
adjustment lever and to remove a misfeed.
☞
Fusing unit pressure adjusting levers
(19) Paper reversing section cover
This is used when 2-sided copying and printing is
performed. Open this cover to remove a paper misfeed.
(20) Bypass tray
Use this tray to feed paper manually.
When loading paper larger than A4R or 8-1/2" x 11"R, be
sure to pull out the bypass tray extension.
☞
LOADING PAPER IN THE BYPASS TRAY
(page 28)
(21) Main power switch
This is used to power on the machine.
When using the fax or Internet fax functions, keep this
switch in the "On" position.
☞
(page 13)
(22) Waste toner box
This collects excess toner that remains after copying and
printing.
(23) Waste toner box release button
Press this button when you need to release the waste
toner box lock to replace the waste toner box or clean the
laser unit.
☞
☞
(24) Handle
Pull this out and grasp it when moving the machine.
(25) Right cover of stand/1 x 500 sheet paper drawer
Right cover of stand/2 x 500 sheet paper drawer
(when a stand/1 x 500 sheet paper drawer or a
stand/2 x 500 sheet paper drawer is installed)
Open this to remove a paper misfeed in tray 3 or tray 4.
(26) Paper tray right side cover
Open this to remove a paper misfeed in tray 1 or tray 2.
(27) Right side cover release lever
To remove a paper jam, pull and hold this knob up to
open the right side cover.
(15)
(16)
(17)
(20)
(19)
(18)
(23)
(22)
(21)
(26) (27)
(25)
(24)
Caution
The fusing unit is hot. Take care not to burn yourself
when removing a paper misfeed.
Do not touch or damage the transfer belt.
This may cause a defective image.
Your service technician will collect the waste toner
box.