Sony MDS-PC3 - Manual (Page 21)

21
4-5-1. Operating the Continuous Playback Mode
1. Entering the continuous playback mode
1 Set the disc in the unit. (Whichever recordable discs or discs for playback only are available.)
2 Rotate the AMS knob and display “CPLAY1MODE”(C34).
3 Press the @/1 button to change the display to “CPLAY1 MID”.
4 When access completes, the display changes to “C = AD = )”.
Note : The numbers “ ” displayed show you error rates and ADER.
2. Changing the parts to be played back
1 Press the @/1 button during continuous playback to change the display as below.
When pressed another time, the parts to be played back can be moved.
2 When access completes, the display changes to “C = AD = )”.
Note : The numbers “ ” displayed show you error rates and ADER.
3. Ending the continuous playback mode
1 Press the x/Z button. The display will change to “CPLAY1MODE”(C34).
2 Press the x/Z“PGM” button to remove the disc.
Note : The playback start addresses for IN, MID, and OUT are as follows.
IN 40h cluster
MID 300h cluster
OUT 700h cluster
4-5-2. Operating the Continuous Recording Mode (Use only when performing self-recording/palyback check.)
1. Entering the continuous recording mode
1 Set a recordable disc in the unit.
2 Rotate the AMS knob and display “CREC 1MODE” (C35).
3 Press the @/1 button to change the display to “CREC1 MID”.
4 When access completes, the display changes to “CREC1 ( )” and REC lights up.
Note : The numbers “ ” displayed shows you the recording position addresses.
2. Changing the parts to be recorded
1 When the @/1 button is pressed during continuous recording, the display changes as below.
When pressed another time, the parts to be recorded can be changed. REC goes off.
2 When access completes, the display changes to “CREC1 ( )” and REC lights up.
Note : The numbers “ ” displayed shows you the recording position addresses.
3. Ending the continuous recording mode
1 Press the x/Z button. The display changes to “CREC 1MODE” (C35 ) and REC goes off.
2 Press the x/Z“PGM” button to remove the disc.
Note 1 : The recording start addresses for IN, MID, and OUT are as follows.
IN 40h cluster
MID 300h cluster
OUT 700h cluster
Note 2 : The x/Z button can be used to stop recording anytime.
Note 3 : Do not perform continuous recording for long periods of time above 5 minutes.
Note 4 : During continuous recording, be careful not to apply vibration.
“CPLAY1 MID” t “CPLAY1 OUT” t “CPLAY1 IN”
“CREC1 MID” t “CREC1 OUT” t “CREC1 IN”