Sony RM-AX4000 - Manual (Page 54)

54
If you want to quit before
finishing
Press and hold the COMMANDER OFF button
for more than 2 seconds. The setting is
canceled, and the Remote Commander turns
off.
If you want to return to the
previous display
Press the BACK button or the COMMANDER
OFF button. The previous LCD display returns.
Notes
• If you interrupt the procedure at any point
for over 2 minutes, the setting is cancelled
and the series of commands (a macro) will be
programmed to that point. In this case, clear
the program (page 54) and start again from
step 1 to set the entire program from the
beginning. You cannot continue from where
you left off.
• If you set the preset code (page 45) or
program a new signal by learning (page 47)
on a key or button that has been
programmed in the System Control macro,
the new signal will be transmitted when you
press the corresponding SYSTEM CONTROL
button or System Control key.
• If you try to program more than 32 steps, the
System Control macro programming finishes,
and the 32 steps you have programmed are
registered. If you want to program again,
clear the program (page 54) and start again
from step 1.
About the order of operation
steps
Some of the components may not accept
consecutive remote control signals. For
example, a TV generally does not react to the
next signal immediately after the Power-on
signal. So, a series of commands such as TV
power-on and input select may not work
properly. In this case, insert other signals like
the example below;
TV power-on
t VCR power-on t VCR
playback t TV input select
To clear programmed series
of commands for SYSTEM
CONTROL button or System
Control key
1
While pressing the
COMMANDER OFF button,
press the MUTING button.
MUTING
OFF
COMMANDER
“SET” appears as the Display title.
SET /1
SU
LEARN
NG
PRESET LEARN MACRO TIMER
2
Press “MACRO” on the Label
keys.
MACRO
“MACRO” appears as the Display
title.
MACRO
SU
LEARN
NG
SYSTEM XPRESS
Programming a series of commands
with just one button (continued)