Sony RM-AX4000 - Manual (Page 51)

51
Setting b
y On-Remote Setup
For accurate learning
• Do not move the remote units during
the learning procedure.
• Be sure to press and hold the button of
the other remote control until you hear
the confirmation beep.
• Use fresh batteries in both remote
control units.
• Avoid learning in places under direct
sunlight or strong fluorescent light.
• The remote control detector area may
differ depending on each remote unit.
If learning does not work, try changing
the positions of the two remote units.
• When you teach a remote control unit
with an interactive signal exchange
system (supplied with some Sony
receivers and amplifiers) to the Remote
Commander, the response signal of the
component may interfere with the
learning of the Remote Commander. In
such a case, move to another room, etc.,
where the signals will not interfere.
IMPORTANT
Be sure to place the Remote Commander
out of the reach of small children or pets.
Also, set the Hold function to lock the all
the buttons on the Remote Commander
(page 33) when it is not used. Devices such
as air conditioners, heaters, electric
appliances, and electric shutters or
curtains receiving an infrared signal can be
dangerous if misused.
Programming a series
of commands with just
one button
–System Control function
With the System Control function, you
can program a series of commands (a
macro) and execute them by pressing just
one button. For example, when you
watch a video, a series of operations like
the ones below are necessary.
Example:
1 Turn on the TV.
2 Turn on the video (VCR).
3 Turn on the amplifier (RCVR).
4 Set the input selector of the
amplifier to VIDEO 1.
5 Set the input mode of the TV to
VIDEO 1.
6 Start video playback.
You can program up to 32 consecutive
operation steps to each of the SYSTEM
CONTROL buttons (1 - 4) or the System
Control keys (SYSTEM 5 - 8).
Continued