Basic.cutting.tips – Woodstock SHOP FOX W1706 User Manual
Page 32
-30-
Model W1706 (Mfg. Since 3/13)
O
PE
R
ATIO
NS
•
Wet.or."Green".Stock: Cutting wood with a moisture
content over 20% causes unnecessary wear on the
blade and yields poor results.
•
Excessive.Warping: Workpieces with excessive
cupping, bowing, or twisting are dangerous to
cut because they are unstable and can move
unpredictably when being cut. DO NOT cut
excessively warped wood.
•
Minor.Warping: Workpieces with slight cupping
can be safely supported if the cupped side faces
the table or fence, as shown in
Figure.39. On the
contrary, a workpiece supported on the bowed side
will rock during a cut, leading to loss of control.
Here.are.some.basic.tips.to.follow.when.operating.the.
bandsaw:
• Keep the upper blade guide assembly adjusted to
within 1" of the workpiece.
• Use the correct blade for the operation.
• Replace, sharpen, and clean blades as necessary.
Make adjustments periodically to keep the saw
running in top condition.
• Use light and even pressure while cutting. Light
contact with the blade makes it easier to follow
lines and prevents extra friction, which reduces
blade life.
• Avoid twisting the blade when cutting around tight
corners. Allow the blade to saw around the corners.
• Do not back the workpiece away from the blade
while the saw is running.
Basic.Cutting.Tips
Because.of.the.unpredictable.nature.
of.cutting.warped.stock,.use.extreme.
caution..The.difference.between.
acceptable.and.unacceptable.warped.
stock.varies.from.machine.to.machine..
If.you.are.in.doubt,.square-up.the.
stock.first.or.do.not.cut.it.
Cut with
this side down
Cut with
this side down
Figure.39. Cutting workpieces with minor
warping.