Scag Power Equipment SCR - Manual (Page 11)

7
Section 3
3.3 TRACTOR (CONT'D)
Travel Speed:
Forward ................................................................................. 0 - 8.5 MPH
Reverse .................................................................................. 0 - 5.0 MPH
3.4 CUTTER DECK
No. of Blades ............................................................................. 3
Width of Cut .............................................................................. 48"
Cutter Blades ............................................................................. Three (3) 16-1/2" (P/N 481997) Marbane Blades
Deck Drive ................................................................................. Belt Driven Electric Clutch Connected to a Drive Shaft to a
Gearbox on the Cutter Deck
Electric Clutch Type ................................................................... Ogura Electric Clutch
Cutting Height Adjustment ........................................................ Four Corner Pin Adjustment, 1.5" to 5" in 1/2" increments
Deck Tilt .................................................................................... Manually by Lifting Deck and Engaging Lock Pin
Drive Shaft................................................................................. Quick-Disconnect Shaft With Two High Speed U-Joints
3.5 GRASS CATCHING SYSTEM
Type ........................................................................................... Out-Front Rear Deck Discharge into Blower which discharges
the Grass Clippings into a Hopper
Hopper ....................................................................................... 90-Gallon Molded Plastic with Osillating Discharge Chute
Discharge Blower ...................................................................... 12" Diameter
Side Discharge ........................................................................... Extra Wide Discharge Opening on the Left Hand Side with Spring
Loaded Discharge Chute
3.6 HYDRAULIC SYSTEM
Hydraulic Oil Filter ................................................................... 10 Micron Spin-on Element Type
Hydraulic Reservoir ................................................................... Nylon; 6 Quart Capacity
3.7 WEIGHTS AND DIMENSIONS
Length ........................................................................................ 95.0"
Tracking Width .......................................................................... 42.0"
Overall Width ............................................................................ 48.0"
Overall Height ........................................................................... 44.0"
Operating Weight ....................................................................... 1160 lbs.
3.8 PRODUCTIVITY
The following chart will aid you in determining how many acres your Scag mower will cut per day.
The chart is an estimate based on 8 hours per day cutting time at 4 MPH with an allowance for overlap and turns.
Cutting Width: 48"
Acres Per Day: 21
-NOTE-
The machine will travel at 8.5 mph for
transport purposes. For best cutting
performance the forward travel speed
should be adjusted depending upon the
cutting conditions.