Scag Power Equipment SCR - Manual (Page 34)

30
Section 7
To avoid injury from burns, allow the mower
to cool before removing the fuel tank cap and
refueling.
Figure 7-3 Engine Fill Cap and Dip Stick
B. Changing Engine Crankcase Oil
After the first 5 hours of operation, change the engine
crankcase oil and replace the oil filter. Thereafter,
change the engine crankcase oil after every 100 hours of
operation or bi-weekly, whichever occurs first. Refer to
the Engine Operator’s Manual furnished with this mower
for specific instructions.
C. Changing Engine Oil Filter
After the first 5 hours of operation, replace the engine oil
filter. Thereafter, replace the oil filter after every 200
hours of operation or every month, whichever occurs
first. Refer to Engine Operator’s Manual for specific
instructions.
Figure 7-4 Engine Oil Drain Plug
Figure 7-5 Engine Oil Filter
A. Filling the Fuel Tank
Fill the fuel tank at the end of each operating day to
within 1 inch below the filler neck. Do not overfill. Use
clean, fresh unleaded gasoline with a minimum octane
rating of 87.
B. Replacing In-Line Fuel Filter Element
The in-line fuel filter (Figure 7-6) should be replaced
after every 500 hours of operation or annually, whichever
occurs first.
1. Close the shutoff valve. Remove the two clamps
securing the fuel filter to the fuel hose. Remove the
fuel filter.
Engine Oil
Filler Cap
Engine Oil
Dip Stick
SCR 2K FCDS
SCR 2K EODP
Engine Oil
Drain Plug
SCR 2K EOF
Engine Oil
Filter
7.5 ENGINE FUEL SYSTEM