Sony WEGA KLV S20G10 - Manual (Page 21)

Connecting the TV
21
KLV-S15G10/KLV-S20G10
2-630-164-11(1)
G:\#Sagyo\#SONY\18 KLV\0402\2630164111 KLV-
S1520G10\01US04INS.fm masterpage:3 columns Right
Conne
cting
the
TV
Satellite Receiver
and Cable/Antenna This scenario shows a SAT Box connected through the video inputs and the
Cable/Antenna connected through the VHF/UHF input. Satellite signals are
selected by the SAT Box through the video inputs while TV signal is
selected by the TV tuner.
To connect a satellite receiver
1 Connect the satellite antenna cable to the satellite receiver’s satellite
input jack.
2 Use A/V and S VIDEO cables to connect the satellite receiver’s AUDIO
and S VIDEO output jacks to the TV’s AUDIO and S VIDEO input
jacks (VIDEO 1 IN).
3 Connect the supplied 75-ohm coaxial cable from the antenna to the
TV’s VHF/UHF input jack.
4 Run the Initial Setup program, as described in “Setting Up the Channel
List” on page 31.
If your satellite receiver is not equipped with S VIDEO, use a
VIDEO cable (yellow) instead of the S VIDEO cable.
z If you connect the
Digital Satellite
Receiver with
component video
cables, see page 23.
VIDEO 3 IN (480p/480i)
P R
P B
AUDIO
S VIDEO
Y
AUDIO OUT
VHF/UHF
(MONO)
R
L
R
L
AUDIO
VIDEO
R
L
VIDEO 1 IN
Rear of TV
A/V cable
Satellite Receiver
75-ohm coaxial
cable
Satellite antenna
cable
S VIDEO cable
S VIDEO
VIDEO (yellow)
AUDIO-L (white)
AUDIO-R (red)
KLV-S15G10
(Continued)
01US02WAR-UC.book Page 21 Sunday, April 3, 2005 5:53 PM