Sennheiser EVOLUTIONWIRELESS SKP 100 - Manual (Page 15)

14
Adjusting settings via the operating menu
When setting up multi-channel systems, please observe the following:
Only the factory-preset frequencies within one frequency bank are inter-
modulation-free (see page 17). Plug-on transmitter and receiver of a
transmission link have to be set to the same frequency. It is vital to
observe the notes on frequency selection on page 17.
Entering a name – “Name”
Via the “ Name ” menu, you can enter a freely selectable name (e.g. the
name of the performer) for the plug-on transmitter.
The name can be displayed on the standard displays “ Frequency/Name ”
and “ Name/Channel ”. The name can consist of up to 8 characters such as:
• letters (without pronounciation marks),
• numbers from 0 to 9,
• special characters and spaces.
To enter a name, proceed as follows:
Activating/deactivating the automatic lock mode – “Auto Lock”
The lock mode prevents that the plug-on transmitter is accidentally
switched off or programed during operation. The lock mode icon
ቦ
on
the current standard display indicates that the lock mode is activated.
For information on how to use the lock mode, refer to page 9.
The extended menu “ Advanced Menu ”
Setting transmission frequencies and the frequency bank “U” –
“Tune”
When you have selected one of the system banks and then select the
“
Tune ” menu, the plug-on transmitter automatically switches to channel 1
of the frequency bank “ U ”. In this case, “ U.1 ” briefly appears on the display
panel. Upon delivery, the channels of the frequency bank “ U ” are not
assigned a transmission frequency.
Via the “ Tune ” menu item, you can set a transmission frequency to be
stored in the current channel or you can select a different channel in the
frequency bank “ U ” and assign it a transmission frequency. It is vital to
observe the notes on frequency selection on page 17.
̈
Press the UP button (
̆
)/ DOWN button (
̄
) to select a
character.
̈
Press the SET button to change to the next segment/
character or to store the complete entry.
̈
Press the UP button (
̆
)/ DOWN button (
̄
) to select the
desired setting.
When you are in the “ Tune ” menu item, the RF signal is
deactivated.
Call up “Name” Enter a character
and confirm Enter a character;
store the entry
Menu
L i c h a e l
Name
Name Name
L i c h a e l M i chael
“Stored”
SET SET
SET
SET
Call up “Auto
Lock” Select the desired
setting
A c t i v e
Auto Lock Active
Auto Lock
I n a c t i v e
Auto Lock Menu
Store the setting
“Stored”
SET
SET
SKP100_529675_0409_Sp9.book Seite 14 Donnerstag, 9. April 2009 1:48 13