ScyTek Electronics A10 SERIES - Manual (Page 6)

Remote Transmitter Description
The Astra A10 is supplied with (2) two-button Remote Transmitters used to control system
operations.
Button 1 Arms and Disarms the system and when held for 2 seconds, activates the system’s Panic
feature. Button 1 also locks and unlocks the doors when the system is in Valet Mode.
Button 2 Arms and Disarms the system silently and when held for 2 seconds or more, activates the
Auxiliary 1 output. This output will remain on for as long as the button is pressed.
Adding/Replacing Transmitters
To replace lost or stolen transmitters or to add additional transmitters into the system, have all
desired transmitters ready and follow the steps below.
Note: Up to 4 transmitters can be programmed to operate the system. To erase any previously
stored transmitter codes, be sure to program all 4 transmitter memory locations.
To program the transmitter(s):
1. Turn on the ignition key On, Off, On, Off, and back On.
· The siren will chirp 3 times.
2. Press and hold the Override switch for 5 seconds.
· The siren will chirp 5 times.
· The LED will illuminate.
3. Press Button 1 on the first transmitter.
· The siren will chirp once.
4. Press Button 1 on the first transmitter again.
· The siren will chirp twice to indicate it has learned the code.
5. Repeat steps 3 and 4 for each transmitter (up to 4).
6. Turn off the ignition key.
Page 2 - Astra A10
Remote Transmitters
Button 1 Button 2
LED