System operation, Remote arming, Remote disarming – ScyTek Electronics A10 SERIES User Manual

Page 8: Silent arming/disarming

Advertising
background image

Page 4 - Astra A10

Remote Arming

The system monitors 3 independent areas (

zones) while armed: doors, hood/trunk, and shock sensor input.

To Arm the System:

1. Turn off the ignition.
2. Press Button 1.

· The siren will chirp once.*

· The doors will lock.

· The parking lights will flash once.

· The LED will turn on red, to indicate the starter defeat is activated.

3. 5 seconds after Arming:

· The LED will start blinking to indicate that the doors and hood/trunk inputs are being monitored.

* During Arming, if the system detects a bad sensor or an open zone, the system will chirp 4 additional times and

ignore that input, but keep all other areas protected.

Once Armed, the alarm will trigger when any of the following occurs:

·

The doors are opened.

·

The hood or trunk is opened.

·

The shock sensor detects an impact to the vehicle.

When the alarm triggers, the siren will sound, the horn will honk, and the parking lights will flash. If

the system is triggered by the doors, or hood/trunk, the system will alarm for 45 seconds. If triggered

by the shock sensor input, the system will alarm for 30 seconds.
In the event the alarm is triggered and remains triggered continuously by the same sensor or input

during a single arming cycle, that sensor or input will be automatically bypassed until the next time

the system is armed.
If the Shock Sensor detects a light impact to the vehicle, the siren will chirp 5 times as a warning

indication.

Remote Disarming

To Disarm the System:

Press Button 1.

· The siren will chirp twice.*

· The doors will unlock.

· The parking lights will flash twice.

· The dome light will turn on.**

· The LED will turn off.

* During Disarming, if the system was triggered while away from the vehicle, the siren will chirp 3 times, and the

parking lights will flash 3 times.

** If the optional Dome Light Activation Feature was installed.

Silent Arming/Disarming

The system can be programmed to operate without Arm and Disarm chirp indications. When programmed

for full-time silent operation, the siren will sound only when the system is triggered.
The system is also capable of temporary silent operation when needed. Pressing button 2 momentarily will

bypass the chirp confirmations and allow one-time silent operation.

Note: The open zone warning chirps will not be bypassed when the system is Armed or Disarmed silently.

System Operation

Advertising