Sony DAVLF1H - Manual (Page 31)

31 US
Ge
tting
Star
te
d –
B
A
SIC –
9
Connect the calibration mic to the
ECM-AC1 jack on the rear of the
subwoofer and set up the calibration
mic at the ear level using a tripod, etc.
(not supplied).
The front of each speaker should face the
calibration mic, and there should be no
obstruction between the speakers and the
calibration mic.
Note
• Place the calibration mic so that the “FRONT”
side of it is pointed toward the front speakers.
10
Press X / x to select [YES], then press
.
[AUTO CALIBRATION] starts. Be quiet
during the measurement.
Note
• Loud test sound is output when [AUTO
CALIBRATION] starts. You cannot turn the
volume down. Give consideration to children
and neighbor.
• Avoid being in the measurement area and
making noise during the measurement (which
takes about 1 minute), as it may interfere with
measurement.
• If the sound of the surround speakers is not
output, adjust the wireless system. See
“Adjusting the IR transmitter and IR receiver of
the surround speaker (L)” (page 29).
• When you install the surround speaker (L) to the
right position, the system sets the “SL SR
REVERSE” setting (page 99) to “ON”
automatically.
11
Unplug the calibration mic and press C /
c to select [YES].
Quick Setup is finished. All connections
and setup operations are complete.
Note
• Reflections from walls or the floor may affect
measurements.
• If measurement fails, follow the message then
retry [AUTO CALIBRATION].
To quit the Quick Setup
Press DISPLAY in any Step.
Tip
• If you cancel [AUTO CALIBRATION], perform the
speaker settings in “Settings for the Speakers”
(page 97).
• If you change the position of the speakers, reset the
speaker settings. See “Calibrating the Appropriate
Settings Automatically” (page 87).
• If you want to change any of the settings, see “Using
the Setup Display” (page 90).
• For details on [AUTO CALIBRATION] and the error
messages of [AUTO CALIBRATION], see
“Calibrating the Appropriate Settings Automatically”
(page 87).
VIDEO 1 VIDEO 2
VIDEO 2
TV VIDEO 1 TV
AUDIO IN AUDIO IN AUDIO IN DIGITAL IN
OPTOCAL
L
R
DIGITAL IN
DIGITAL
IN
COAXIAL
COAXIAL
ECM-AC1
Calibration mic
Rear of the subwoofer
FRONT L :
FRONT R :
CENTER :
SUBWOOFER :
SURROUND L :
SURROUND R :
If OK, unplug calibration mic and select
YES.
YES
16ft 4.8m 0.0dB
16ft 4.8m 0.0dB
16ft 4.8m + 1.0dB
16ft 4.8m + 4.0dB
10ft 3.0m - 2.0dB
10ft 3.0m - 2.0dB
Measurement complete.
NO
continued