Sharp Electronic Organizer El-6850 - Manual (Page 3)

1
Using the Organizer for the First Time
Be sure to perform the following operations before using the
Organizer for the first time.
1. Press the RESET switch while holding ON . Release the
RESET switch and then release ON .
“CLEAR ALL DATA OK (Y/N) ?” is displayed.
• Under certain conditions the message may appear as
“Data has been impaired ! Press [Y] to CLEAR ALL
memory”. Proceed to the next step in either case.
2. Press Y .
3. The Organizer is now initialized. Proceed to set the date
and time of the clock. (Refer to page 7.)
Press the RESET switch with a ball-point pen or similar
object. Do not use an object with a breakable or sharp tip.
When Abnormal Conditions Cause a Malfunction
If the Organizer is subjected to strong, extraneous electrical
noises or shocks during use, an abnormal condition may
occur in which no keys (including
ON ) will respond. If this
happens, press the RESET switch.
Noises or shocks may erase some or all of the Organizer’s
memory.
Auto Power Off Function
When none of the keys have been pressed for approximately
7 minutes, the Organizer automatically turns the power off to
save the batteries. (The actual time may vary depending upon
the condition of use.) Press
ON to resume operation.
Backlight
The Organizer provides a built-in Backlight, which allows you
to view the display and use the Organizer even in low-light
conditions. Pressing
once illuminates the display for as
long as you continue to use the Organizer, until you have not
typed any key for the interval you set. (See the following
section, “Setting up the Backlight”.)