Sennheiser Quadpack qp 3041 User Manual
Page 25
26
26
Mounting the antennas to the front of the Quadpack
If your Quadpacks are to be mounted into a rack or a tower, the antennas
can be connected to the front side by using the GA 3030 AM antenna mount
(see „Accessories” on page 31).
̈
Mount the antenna holders
¿
to the two outer handles of the two Quad-
packs as shown in the diagram on the left. Fasten the antenna holders by
means of the supplied four screws and plain washers to the prepared
holes.
̈
Guide the two cables sideways to the rear of the Quadpacks.
If you wish to mount the two Quadpacks into a rack, fix the two
cables
»
of the GA 3030 AM antenna mount to the rack mount
“ears”
·
as shown in the diagram on the left.
̈
Connect the two telescopic antennas to the antenna holders
¿
and align
the antennas upwards.
Daisy-chaining two Quadpacks
If you daisy-chain two Quadpacks and mount them side by side into a rack,
they can be operated with only one pair of antennas. This pair of antennas
can be connected to the front of the rack as described above.
̈
Connect one antenna or one cable
»
of the GA 3030 AM antenna
mount to the BNC socket “ANT. A”
ƺ
of each Quadpack.
*
= to the antennas mounted to the front of the rack.
̈
Connect the BNC socket “RF OUT A”
Ƽ
of each Quadpack to the BNC
socket “ANT. B”
ƻ
of the other Quadpack as shown in the diagram
above.
¿ » ·
ƻ ƺ
ƻ
Ƽ
Ƽ
ƺ
# !"