Schwinn 460 - Manual (Page 13)

Console Interface Display
The console has a grid display with touch screen control buttons to
navigate you through the Schwinn ® 460 exercise machine programs.
Auto Shut-Off (Sleep Mode)
If the console does not receive any input within approximately five minutes it will automatically shut off. In SLEEP MODE
the backlit display is off.
Note: There is no on/off switch.
Power-Up Mode
The machine will enter POWER-UP MODE if the console is
plugged into a power source, any button is pressed or if it
receives a reading from the RPM sensor as a result of pedaling
the machine.
1. Plug in and push any button on the console or begin pedaling
to power up the console computer.
Console Setup Mode
The CONSOLE SETUP MODE allows you to set the units of measure to either METRIC or ENGLISH, adjust the
contrast of the display and turn off the motivational messages. Motivational messages show on the screen to
increase your enthusiasm and to give positive feedback while you are working out.
1. Hold down the START/ENTER button and STOP/RESET button
together for 5 seconds while in the POWER-UP MODE to
enter the CONSOLE SETUP MODE.
2. Press (+ /-) to change between ENGLISH and METRIC units.
3. Press START / ENTER to select.
4. Press (+ / -) to adjust the screen contrast.
5. Press START / ENTER to select .
6. Press (+ / -) to turn motivational messages off or on.
7. Press START / ENTER to select.
8. Press STOP / RESET for previous screen.
Operation
Console with all segments illuminated
Owner’s Manual
11