SMC Networks EliteConnect SMCWHSG14-G - Manual (Page 20)

SMCWHSG14-G
19
2-4 Getting Start
1. Place the Wireless Hotspot Gateway and AG-200E Printer on a flat work surface.
2. Connect the Ethernet cable to the Wireless Hotspot Gateway’s LAN port.
3. Connect the other end of the Ethernet cable to the AG-200E Account Generator Printer’s RJ45 port.
4. Ensure that your modem and computer are both switched on.
5. Use the supplied cable to connect the Wireless Hotspot Gateway 's WAN port to the modem. Check
that the Cable/xDSL Status LED lights.
6. Connect your computer to one of the 10/100 LAN ports on the Wireless Hotspot Gateway . Check
that the LAN Port Status LED lights.
7. Configure the further parameters via a Web browser.
Figure 2-4 Wireless Hotspot Gateway Connection