Sony VGP-MR200U/E - Manual (Page 15)

Setup
15
1 Prepare the remote control for use
Inserting the batteries
As shown in the illustration, open the battery cover lid of the remote control, and insert two AA
(R6) batteries (supplied).
Using the remote control
To use the remote control, point it towards the remote control sensor on the Network Media
Receiver, and press the appropriate buttons.
z
Hints
• If the operating range of the remote control decreases, replace both batteries with fresh ones.
• After replacing the batteries, the TV manufacturer code (pages 16, 17) must be set again.
Verify e/E polarities, and
insert the batteries from the E
side.
Remote control sensor